"**What this part does**
Guides the new shaft seal over the shaft splines and step so the seal lip is not cut, rolled or turned back while the seal is pressed into place.
**Where it is installed**
The Shaft Seal Installer Sleeve is located over the compressor shaft, where it is used during shaft seal replacement.
**Symptoms of a failed seal installer**
A worn or damaged seal installer shows up as one or more of these symptoms:
- A new shaft seal that leaks immediately after fitting (lip cut or rolled on installation)
- Seal lip turned back or shaved during pressing
- Repeated seal failure each time the compressor is rebuilt
**When to replace**
Use the installer every time a shaft seal is fitted. Replace the sleeve if it is damaged or missing.
**Why choose this part**
Supplied as a direct replacement for the original part. Always compare the dimensions, hole layout and finish with your original part before ordering.
**Ordering note**
Confirm the sleeve suits the shaft diameter of this compressor before ordering.
"
